Apollo Pager Programming Guide
Programming the Apollo Pager
Step 1: Remove the battery. Re-insert battery while holding down (3) until password appears, then let off (3). The password will be either “0000” or “2095”.
Step 2: Press (4) one time until the frequency is displayed on the screen. Press (2) to select the digit to change on the screen. Press (3) to change to the desired digit. Repeat until desired frequency is set (467.8000 default). Use (2) to scroll over to WB or NB and set to desired bandwidth by pressing (3) (NB default).
Step 3: Press (4) one time until capcode is displayed on the screen. First verify that the desired capcode is set to “ON”, then using (2), scroll through the digits to set the correct capcodes using (3) until the desired code is set. Also verify the last four letters are set to “AAAA”.
Step 4: Continue pressing (4) to set up to 6 different capcodes if needed. Use the same procedure from Step 3 if additional capcodes are needed.
Step 5: Press (4) until is baud = displayed on the screen. Press (3) until desired baud is displayed (512 default).
Step 6: Press (4) until modify password is displayed (0000 default). Use (2) to scroll through digits and (3) to set the digits if desired.
Step 7: Press (4) until adjust contrast is displayed. This can be changed if desired, however the default is 5.
Step 8: Pressing (4) one more time will display pass. The pager will then restart and display the time and date.
